Your continued donations keep Wikipedia running!    

Colossus computer

From Wikipedia, the free encyclopedia

Jump to: navigation, search
A Colossus Mark II computer. The slanted control panel on the left was used to set the pin patterns on the Lorenz; the paper tape transport is on the right.
Enlarge
A Colossus Mark II computer. The slanted control panel on the left was used to set the pin patterns on the Lorenz; the paper tape transport is on the right.

The Colossus machines were early computing devices used by British codebreakers to read encrypted German messages during World War II. Colossus was an early electronic digital computer.

Colossus was designed by engineer Tommy Flowers at the Post Office Research Station, Dollis Hill. The prototype, Colossus Mark I, was operational at Bletchley Park in February 1944. An improved Colossus Mark II was first installed in June 1944, and ten Colossi had been constructed by the end of the war.

The Colossus computers were used to help decipher teleprinter messages which had been encrypted using the Lorenz SZ40/42 machine. Colossus compared two data streams, counting each match based on a programmable boolean function. The encrypted message was read at high speed from a paper tape. The other stream was generated internally, and was an electronic simulation of the Lorenz machine at various trial settings. If the match count for a setting was above a certain threshold, it would be output on an electric typewriter.

Contents

[edit]

Purpose and origins

The Lorenz machine was used by the Germans to encrypt high-level teleprinter communications. It contained 12 wheels with a total of 501 pins.
Enlarge
The Lorenz machine was used by the Germans to encrypt high-level teleprinter communications. It contained 12 wheels with a total of 501 pins.

The Colossus computers were used in the cryptanalysis of high-level German communications, messages which had been encrypted using the Lorenz SZ 40/42 cipher machine; part of the operation of Colossus was to emulate the mechanical Lorenz machine electronically. To encrypt a message with the Lorenz machine, the plaintext was combined with a stream of key bits, grouped in fives. The key stream was generated using twelve pinwheels: five were termed (by the British) χ ("chi") wheels, another five ψ ("psi") wheels, and the remaining two the "motor wheels". The χ wheels stepped regularly with each letter that was encrypted, while the ψ wheels stepped irregularly, controlled by the motor wheels.

Bill Tutte, a cryptanalyst at Bletchley Park, discovered that the keystream produced by the machine exhibited statistical biases deviating from random, and that these biases could be used to break the cipher and read messages. In order to read messages, there were two tasks that needed to be performed. The first task was wheel breaking, which was discovering the pin patterns for all the wheels. These patterns were set up once on the Lorenz machine and then used for a fixed period of time and for a number of different messages. The second task was wheel setting, which could be attempted once the pin patterns were known. Each message encrypted using Lorenz was enciphered at a different start position for the wheels. The process of wheel setting found the start position for a message. Initially Colossus was used to help with wheel setting, but later it was found it could also be adapted to the process of wheel breaking as well.

Colossus was operated in the Newmanry, the section at Bletchley Park responsible for machine methods against the Lorenz machine, headed by the mathematician Max Newman.

Colossus developed out of a prior project which produced a special purpose opto-mechanical comparator machine called "Heath Robinson". The main problem with Robinson was synchronising two paper tapes, one punched with the enciphered message, the other representing the patterns produced by the wheels of the Lorenz machine, that tended to stretch when being read at over 1000 characters per second, resulting in unreliable counts. Colossus solved this problem by reproducing one of the tapes electronically. The remaining single tape could be fed through Colossus at a higher speed and could be counted much more reliably.

[edit]

The construction of Colossus

A team headed by Tommy Flowers spent ten months (early February to early December 1943) designing and building Colossus at the Post Office Research Station, Dollis Hill, in northwest London. After a functional test on 8 December 1943, Colossus was dismantled, shipped north to Bletchley Park, and assembled in F Block over Christmas 1943. The Mark 1 succeeded in its first test against a real enciphered message tape in January 1944.[1] It was followed by nine Mark 2 Colossus machines, the first being installed in June 1944, and the original Mark I machine was converted into a Mark 2. An eleventh Colossus was essentially finished at the end of the war.

Colossus Mark 1 contained 1,500 electronic valves. Colossus Mark 2 with 2,400 valves was both 5 times faster and simpler to operate than Mark 1 and so greatly speeded the decoding process. Mark 2 was designed while Mark 1 was being constructed. For comparison, later stored-program computers like ENIAC in 1946 used 17,468 valves and the Manchester Mark I of 1949 used about 4,200.

Colossus dispensed with the second tape of the Heath Robinson design by generating the wheel patterns electronically, and processing 5,000 characters per second with the paper tape moving at 40 ft/s = 12 m/s = 30 mph. The circuits were synchronized by a clock signal generated by the punched tape. The speed of calculation was thus limited by the mechanics of the tape reader. Designer Tommy Flowers tested the tape reader up to 9700 character/s (60 mph) before the tape disintegrated. He settled on 5000 characters/second as the desirable speed for regular operation. Sometimes, two or more Colossus computers tried different possibilities simultaneously in what now is called parallel computing, greatly speeding the decoding process.

Colossus included the first ever use of shift registers and systolic arrays, enabling five simultaneous tests, each involving up to 100 Boolean calculations, on each of the five channels on the punched tape (although in normal operation only one or two channels were examined in any run).

Initially Colossus was only used to determine the initial wheel positions used for a particular message (termed wheel setting). The Mark 2 included mechanisms intended to help determine pin patterns (wheel breaking). Both models were programmable using switches and plug panels in a way the Robinsons had not been.

[edit]

Design and operation

In 1994, a team led by Tony Sale began a reconstruction of a Colossus.
Enlarge
In 1994, a team led by Tony Sale began a reconstruction of a Colossus.

Colossus used state-of-the-art vacuum tubes (thermionic valves), thyratrons and photomultipliers to optically read a paper tape and then applied a programmable logical function to every character, counting how often this function returned "true". Although machines with many valves were known to have high failure rates, it was recognised that valve failures occurred most frequently with the current surge at power on, so the Colossus machines, once turned on, were never powered down unless they malfunctioned.

Colossus was the first of the electronic digital machines to feature limited programmability. However, it was not a fully general purpose computer, not being Turing-complete, even though Alan Turing on whose research this definition was based, worked at Bletchley Park where Colossus was put into operation. It was not then realized that Turing-completeness was significant; most of the other pioneering modern computing machines were not either (e.g. the Atanasoff-Berry Computer, the Harvard Mark I electro-mechanical relay machine, the Bell Labs relay machines (by George Stibitz et al), Konrad Zuse's first two designs, and so on). The notion of a computer as a general purpose machine, and not simply a massive calculator devoted to solving difficult but single-minded problems, did not become prominent until a few years later.

Colossus was preceded by several computers, many of them first in some category. Zuse's Z3 was the first functional fully program-controlled computer, and was based on electromechanical relays, as were the (less advanced) Bell Labs machines of the late 1930s (George Stibitz, et al). The ABC Computer was electronic and binary (digital) but not programmable. Assorted analog computers were semiprogrammable; some of these much predated the 1930s (eg, Vannevar Bush). Babbage's Analytical engine antedated all these (in the mid-1800s), and was both digital and programmable, but was only partially constructed and never functioned at the time (a replica of his Difference engine No. 2, built in 1991, does work, however). Colossus was the first combining digital, (partially) programmable, and electronic.

Defining characteristics of five first operative digital computers
Computer Nation Year Digital Binary Electronic Programmable Turing
complete
Atanasoff-Berry Computer USA 1937−42 Yes Yes Yes No No
Zuse Z3 Germany 1941 Yes Yes No Fully, by paper tape Yes
Colossus computer UK 1944 Yes Yes Yes Partially, by rewiring No
Harvard Mark I/IBM ASCC USA 1944 Yes No No By paper tape Yes
ENIAC USA 1946 Yes No Yes Partially, by rewiring Yes
[edit]

Influence and fate

The use to which the Colossi were put was of the highest secrecy, and the Colossus itself was highly secret, and remained so for many years after the War. Thus, Colossus could not be included in the history of computing hardware for many years, and Flowers and his associates also were deprived of the recognition they were due.

Being not widely known, it therefore had little direct influence on the development of later computers; EDVAC was the early design which had the most influence on subsequent computer architecture.

However, the technology of Colossus, and the knowledge that reliable high-speed electronic digital computing devices were feasible, had a significant influence on the development of early computers in Britain. A number of people who were associated with the project and knew all about Colossus played significant roles in early computer work in Britain. In 1972, Herman Goldstine wrote that:

"Britain had such vitality that it could immediately after the war embark on so many well-conceived and well-executed projects in the computer field"[1].

In writing that, Goldstine was unaware of Colossus, and its legacy to those projects of people such as Alan Turing (with the Pilot ACE and ACE), and Max Newman and I. J. Good (with the Manchester Mark I and other early Manchester computers). Brian Randell later wrote that:

"the COLOSSUS project was an important source of this vitality, one that has been largely unappreciated, as has the significance of its places in the chronology of the invention of the digital computer"[2].

Colossus documentation and hardware were classified from the moment of their creation and remained so after the War, when Winston Churchill specifically ordered the destruction of most of the Colossus machines into 'pieces no bigger than a man's hand'; Tommy Flowers personally burned blueprints in a furnace at Dollis Hill. Some parts, sanitised as to their original use, were taken to Newman's Computing Machine Laboratory at Manchester University. The Colossus Mark I was dismantled and parts returned to the Post Office. Two Colossus computers, along with two replica Tunny machines, were retained, moving to GCHQ's new headquarters at Eastcote in April 1946, and moving again with GCHQ to Cheltenham between 1952 and 1954[3]. One of the Colossi, known as Colossus Blue, was dismantled in 1959; the other in 1960[3]. In their later years, the Colossi were used for training, but before that, there had been attempts to adapt them, with varying success, to other purposes[4]. Jack Good relates how he was the first to use it after the war, persuading the NSA that Colossus could be used to perform a function for which they were planning to build a special purpose machine[3]. Colossus was also used to perform character counts on one-time pad tape to ensure their randomness[3].

Information about Colossus began to emerge publicly in the late 1970s, after the secrecy imposed by the Official Secrets Act ended in 1976. More recently, a 500-page technical report on the Tunny cipher and its cryptanalysis – entitled General Report on Tunny – was released by GCHQ to the national Public Record Office in October 2000; the complete report is available online [2], and it contains a fascinating paean to Colossus by the cryptographers who worked with it:

It is regretted that it is not possible to give an adequate idea of the fascination of a Colossus at work; its sheer bulk and apparent complexity; the fantastic speed of thin paper tape round the glittering pulleys; the childish pleasure of not-not, span, print main header and other gadgets; the wizardry of purely mechanical decoding letter by letter (one novice thought she was being hoaxed); the uncanny action of the typewriter in printing the correct scores without and beyond human aid; the stepping of the display; periods of eager expectation culminating in the sudden appearance of the longed-for score; and the strange rhythms characterizing every type of run: the stately break-in, the erratic short run, the regularity of wheel-breaking, the stolid rectangle interrupted by the wild leaps of the carriage-return, the frantic chatter of a motor run, even the ludicrous frenzy of hosts of bogus scores. [3]
[edit]

Reconstruction

A construction of a replica of a Colossus Mark II has been undertaken by a team led by Tony Sale. The reconstruction is on display in the Bletchley Park Museum in Milton Keynes, Buckinghamshire.

[edit]

See also

[edit]

Footnotes

  1. ^ The Computer from Pascal to von Neuman (pp. 321)
  2. ^ The COLOSSUS, pp. 87
  3. ^ a b c d Copeland, 2006, p. 173-175
  4. ^ Horwood, 1973
[edit]

References

[edit]

Further reading

  • Harvey G. Cragon, From Fish to Colossus: How the German Lorenz Cipher was Broken at Bletchley Park (Cragon Books, Dallas, 2003; ISBN 0974304506) – A detailed description of the cryptanalysis of Tunny, and some details of Colossus (contains some minor errors)
  • Ted Enever, Britain's Best Kept Secret: Ultra's Base at Bletchley Park (Sutton Publishing, Gloucestershire, 1999; ISBN 0750923555) – A guided tour of the history and geography of the Park, written by one of the founder members of the Bletchley Park Trust
  • Tony Sale, The Colossus Computer 1943–1996: How It Helped to Break the German Lorenz Cipher in WWII (M.&M. Baldwin, Kidderminster, 2004; ISBN 0947712364) – A slender (20 page) booklet, containing the same material as Tony Sale's website (see below)
  • Michael Smith, Station X, 1998. ISBN 0330419293.
  • Paul Gannon, "Colossus Bletchley Park's Greatest Secret" 2006 Atlantic Books; ISBN 1843543303.
  • Jack Copeland: Colossus. The Secrets of Bletchley Park's Codebreaking Computers. Oxford University Press 2006. ISBN 019284055X


[edit]

Other meanings

There was a fictional computer named Colossus in the movie Colossus: The Forbin Project. Also see List of fictional computers.

[edit]

External links

Retrieved from "http://en.wikipedia.org/wiki/Colossus_computer"
Personal tools